NX 9.0 - Modeling Assay
NX 9.0 - Modeling Assay
(OP)
Hi,
How would you create a fully parameterized part, using the Body(0) in the attached part file, as a model?
Thanks,
USSagittarius
How would you create a fully parameterized part, using the Body(0) in the attached part file, as a model?
Thanks,
USSagittarius





RE: NX 9.0 - Modeling Assay
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 9.0 - Modeling Assay
You were right, there are only some aspects of it that I'd like to modify.............
I am able to create this component easily, except the read area located I this new attachment.
I just do not know how to create it!
Maybe I have concentrated to much to this job in order to get an idea and me inspiration went away!.......
How would you create that red area?
Thanks for your time!
USSagittarius
RE: NX 9.0 - Modeling Assay
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 9.0 - Modeling Assay
Any related thoughts?
USSagittarius