Steering knuckle reading and tie rod taper tolerancing
Steering knuckle reading and tie rod taper tolerancing
(OP)
Howdy all,
I'm finding myself assisting in the design and tolerancing of a steering knuckle. Any recommendations on standards and reference materials?
Also, are there any standard ways of toleracing the tapers for tie rod and ball joints? I've found some machine tool / morse taper tolerance standards, but not much on tie rods.
Jason
I'm finding myself assisting in the design and tolerancing of a steering knuckle. Any recommendations on standards and reference materials?
Also, are there any standard ways of toleracing the tapers for tie rod and ball joints? I've found some machine tool / morse taper tolerance standards, but not much on tie rods.
Jason





RE: Steering knuckle reading and tie rod taper tolerancing
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376: Eng-Tips.com Forum Policies http://eng-tips.com/market.cfm?