Does anyone or has anyone experienced axial grooves(crank to head)all the way around(360 degrees) a cylinder of a reciprocating compressor? This is our 3rd time this has happened. We're also breaking distance piece to cylinder bolts on the low end. Any experience on this matter would be great. I have a couple of possible causes, but if anyone has any suggestions or opinions that would help me narrow down potential causes that would be great.
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Cities are ceaseless engines of engineering activity. Itâ€™s likely that while you were on your way to work, you encountered a number of infrastructure development projects under construction. Download Now
When was the last time you drove down the highway without seeing a commercial truck hauling goods?The ubiquity of these machines underscores the important roll they play in modern commerce. Download Now