reattaching an assembly cut sketch
reattaching an assembly cut sketch
(OP)
Hello,
I'm trying to understand assembly cut. I created one in my assembly by extruding a cylinder and cutting one of my components and it works fine. However, if I wanted to reattach that sketch to another face in the assembly, when I edit the sketch, none of the components are visible. I checked layers and reference sets and everything is visible. Am I missing something? I'm guessing it's something simple? I've attached a picture to show what's going on.
Thanks,
Al
I'm trying to understand assembly cut. I created one in my assembly by extruding a cylinder and cutting one of my components and it works fine. However, if I wanted to reattach that sketch to another face in the assembly, when I edit the sketch, none of the components are visible. I checked layers and reference sets and everything is visible. Am I missing something? I'm guessing it's something simple? I've attached a picture to show what's going on.
Thanks,
Al
Design Drafter
Alliant Techsystems





RE: reattaching an assembly cut sketch
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: reattaching an assembly cut sketch
Thanks
Design Drafter
Alliant Techsystems