Show Coordinate system with x, y, z axis annotation on drawing
Show Coordinate system with x, y, z axis annotation on drawing
(OP)
Hello everybody,
I want to show the Coordinate System on the drawing with axis annotation.
I can see the coordinate System on the drawing, but when I make a PDF File from it, the axis annotation with x,y,z is not shown. Is there any possibility?
Or do I have to create a custom symbel for this issue?
Thanks
I want to show the Coordinate System on the drawing with axis annotation.
I can see the coordinate System on the drawing, but when I make a PDF File from it, the axis annotation with x,y,z is not shown. Is there any possibility?
Or do I have to create a custom symbel for this issue?
Thanks





RE: Show Coordinate system with x, y, z axis annotation on drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Show Coordinate system with x, y, z axis annotation on drawing
I tried the following:
1) hide the csys.
2) create a now coordinate system
3) but on the drawing there are no x,yz, annotations...
What have I done wrong?
Thanks
RE: Show Coordinate system with x, y, z axis annotation on drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Show Coordinate system with x, y, z axis annotation on drawing
I am using NX 8.5. How I can create only a WCS?
There will be each time created a CSYS...
Thanks...
RE: Show Coordinate system with x, y, z axis annotation on drawing
I have to use Format-> WCS-> Save!
A WCS is at the beginning in the part.
But after user the save function, a green little WCs will be created =)
Thanks, it works!