How to apply Line Load in through thickness direction for Plane Strain model?
How to apply Line Load in through thickness direction for Plane Strain model?
(OP)
Hello,
I have 2D plane strain model as shown in the figure:

I want to apply line load in through thickness direction at the center of circle quarter section. Can somebody please guide me about the controls/commands for the same?
Thank you in advance,
Nik
I have 2D plane strain model as shown in the figure:

I want to apply line load in through thickness direction at the center of circle quarter section. Can somebody please guide me about the controls/commands for the same?
Thank you in advance,
Nik





RE: How to apply Line Load in through thickness direction for Plane Strain model?
RE: How to apply Line Load in through thickness direction for Plane Strain model?
I want to apply force per unit length along the thickness direction. The location will be at the center of cylinder (which is modeled as quarter section above to exploit symmetry)
Thanks in advance for any suggestions