Abaqus - Contact Simulation. Unable to achieve contact
Abaqus - Contact Simulation. Unable to achieve contact
(OP)
Hello everyone
I am new to this group. I am currently doing project on freewheel device and i am trying to simulate a contact model of freewheel mechanism using ABAQUS.
I have made the CAD on SolidWokrs and imported the assembly file (format : Parasolid *x_t). I followed the general procedures for simulating 'Surface-to-Surface' contact.
But so far, I am unable to achieve the contact. The models just simply pass by each other.
I am new to this group. I am currently doing project on freewheel device and i am trying to simulate a contact model of freewheel mechanism using ABAQUS.
I have made the CAD on SolidWokrs and imported the assembly file (format : Parasolid *x_t). I followed the general procedures for simulating 'Surface-to-Surface' contact.
But so far, I am unable to achieve the contact. The models just simply pass by each other.





RE: Abaqus - Contact Simulation. Unable to achieve contact
*********************************************************
Are you new to this forum? If so, please read these FAQs:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083
RE: Abaqus - Contact Simulation. Unable to achieve contact
Even i looked at the .cae file myself and worked on it before, he has assigned normal contact to the model.
Nithin
RE: Abaqus - Contact Simulation. Unable to achieve contact