Face milling error
Face milling error
(OP)

Hi
I have questions about setting the face milling by using the "point boundary" method.
As shown in the pic, there is no error when I used the "face boundary" method, but there is an error when i tried to define the square by selecting 4 points.
Thanks
http://files.engineering.com/getfile.aspx?folder=9...





RE: Face milling error
Or call GTAC and let them go through it with you.
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: Face milling error
And I will contact the GTAC if I found anything.
Thanks