Reset Component to Absolute
Reset Component to Absolute
(OP)
I have a component in an Assembly ... it is not constrained, it has been oriented using the Move command.
Is there anyway that I can "reset" it, as if it was added using Absolute origin ?
Is there anyway that I can "reset" it, as if it was added using Absolute origin ?
NX 9.0.3.4
NX 10.0.1.4 (Testing)
Windows 7 64 (Windows 8.1 Tablet)





RE: Reset Component to Absolute
www.nxjournaling.com
RE: Reset Component to Absolute