NX9.0 chamfer tool issues
NX9.0 chamfer tool issues
(OP)
I have tried and tried to use a flat nose chamfer tool such as a Tungaloy 45 degree Jetmill (ECC31005ru-45) and even a simple 6-flute Iscar carbide chamfer tool. I would use them for chamfering edges or even as simple as chamfering a hole to be tapped. I set the tool parameters in "Create Tool" and the software will not allow me to use a flat nose tool for anything! I'm not buying new tooling just because the software is too stupid to figure it out!!





RE: NX9.0 chamfer tool issues
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX7.5, NX9.0, NX10.0(Testing)
Vericut7.3.3
RE: NX9.0 chamfer tool issues
RE: NX9.0 chamfer tool issues
See the attached image from NX9.0
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX7.5, NX9.0, NX10.0(Testing)
Vericut7.3.3
RE: NX9.0 chamfer tool issues
For the tools...
For countersinking, create a hole_making > countersink tool as shown in the attachment.
For milling, create a chamfer_mill tool like John said.
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: NX9.0 chamfer tool issues
RE: NX9.0 chamfer tool issues
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: NX9.0 chamfer tool issues