Electro-galvanisation Electroplating tolerances
Electro-galvanisation Electroplating tolerances
(OP)
Hello all!
Does anyone know if there is a standard for electro-galvanisation / electroplating regarding the thickness tolerances of the coating, based on the surface length, geometry, thickness, etc?
I've searched online but I can't seem to find this kind of information.
Can someone point me in the right direction?
Any help is massively appreciated!
Best regards to you all!
Does anyone know if there is a standard for electro-galvanisation / electroplating regarding the thickness tolerances of the coating, based on the surface length, geometry, thickness, etc?
I've searched online but I can't seem to find this kind of information.
Can someone point me in the right direction?
Any help is massively appreciated!
Best regards to you all!





RE: Electro-galvanisation Electroplating tolerances
----------------------------------------
The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
RE: Electro-galvanisation Electroplating tolerances
RE: Electro-galvanisation Electroplating tolerances