How to set CSYS (absolute coordinate system)
How to set CSYS (absolute coordinate system)
(OP)



http://files.engineering.com/getfile.aspx?folder=3...
http://files.engineering.com/getfile.aspx?folder=0...
Hi everyone,
I have question about setting up the CSYS.
The origin of the absolute coordinate system is on top. I wish to set it on the bottom, same spot as WCS, MCS...
Although I set WCS, MCS and reference to the bottom of the part. But it seems that all these three coordinate system are taking the CSYS(absolute coordinate system) as the reference.
Can anyone help?
Attached are the screen shots, 111111 & 22222
Thanks





RE: How to set CSYS (absolute coordinate system)
Now this can be done either in the detail part itself, or you could create a Master Model assembly where you add the part as a Component at whatever location and orientation that you wish and then simply use this part file for whatever you intended (sounds like you're planning some manufacturing operations, like tool path generation).
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: How to set CSYS (absolute coordinate system)
"Know the rules well, so you can break them effectively."
-Dalai Lama XIV
RE: How to set CSYS (absolute coordinate system)
RE: How to set CSYS (absolute coordinate system)
It is mainly a permanent reference.
In CAM you use WCS for input, and MCS for output, and i fyou want to input in MCS coordinates, you can set a preference for the WCS to always align with the active MCS.
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: How to set CSYS (absolute coordinate system)
When I define the origin of WCS on the bottom. In manufacturing simulation, I need to add the height of the block to the "translation in Z axis" . Otherwise, the machine will mill through the whole part.
When I define the origin of WCS on the top, I don't need to make any change in the simulation, it seems that it is because the origin of the absolute coordinate system is the same as the WCS. Machine will just mill the designated pocket on the top.
There is probably something wrong with the code output of the APT format that I chose. It only calculated according to absolute coordinate, ignored the WCS ect. Or I might set the parameters wrong. Still need to find out more.
Thanks
RE: How to set CSYS (absolute coordinate system)
If you are new to NX CAM, the geometry view of the Operation Navigator determines which MCS each operation uses. So be sure that your operation is under an MCS group, and that MCS is where you want it.
An easy check is to list the tool path, which uses the MCS coordinates.
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: How to set CSYS (absolute coordinate system)
Yes, it could be.
Thanks for your help.
RE: How to set CSYS (absolute coordinate system)
CODE -->
If you are not getting MCS, please contact GTAC so that they can investigate and log a problem report if needed.
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: How to set CSYS (absolute coordinate system)
Thanks for helping.
RE: How to set CSYS (absolute coordinate system)
I used NX 10.0.2. It's possible the problem you see has been fixed - this is why you should contact GTAC. They can try your test case in the latest version.
Mark Rief
NX CAM Customer Success
Siemens PLM Software