Turbine Spec.
Turbine Spec.
(OP)
Hi all,
I am having a little bit of trouble reading this spec, I have attached a view of the spec.
1) The view is from the governor, I'm assuming it's behind the inlet and outlet (they are on the same side). Where is the governor located?
2) Inlet Flange: "FORWARD FROM CENTERLINE OF EXHAUST OF 0.049".. What does that mean?
3) Lastly, what does "TURBINE SHAFT RISE AT STEAM AND BEARING 0.011" mean?
Thank you all in advance,
eng741
I am having a little bit of trouble reading this spec, I have attached a view of the spec.
1) The view is from the governor, I'm assuming it's behind the inlet and outlet (they are on the same side). Where is the governor located?
2) Inlet Flange: "FORWARD FROM CENTERLINE OF EXHAUST OF 0.049".. What does that mean?
3) Lastly, what does "TURBINE SHAFT RISE AT STEAM AND BEARING 0.011" mean?
Thank you all in advance,
eng741





RE: Turbine Spec.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
RE: Turbine Spec.
The governor is typically on end of the driven shaft.
http://www.elliott-turbo.com/Files/Admin/Literatur...
RE: Turbine Spec.
I attached a plan view and will send another view as well.
If you could help me out on the questions it would be much appreciated.
Thanks in advance,
eng741
RE: Turbine Spec.
I attached another view.
Thank you all in advance,
eng741
RE: Turbine Spec.
Johnny Pellin