Sketch and Datum question
Sketch and Datum question
(OP)
Hello,
Whenever I create a sketch, I use a datum csys and it always brings the datum inside of the sketch.
So I have to exit the sketch and right click to make the datum external.
Is there a setting so that the sketch does not make the datum internal?
Using NX9.
TIA!
Whenever I create a sketch, I use a datum csys and it always brings the datum inside of the sketch.
So I have to exit the sketch and right click to make the datum external.
Is there a setting so that the sketch does not make the datum internal?
Using NX9.
TIA!
UGNX 8 / 8.5 / 9 - Windows 7 64bit
Productive Design Services
www.productivedesign.com





RE: Sketch and Datum question
www.nxjournaling.com