Need Copy of The Machinist's Handbook Chart for Jig Boring
Need Copy of The Machinist's Handbook Chart for Jig Boring
(OP)
Hi Everyone.
I am in need of a copy of the jig boring chart found in the Machinist's Handbook, entitled, "Lengths of Chords for Spacing Off the Circumferences of Circles with a Diameter Equal to 1." In my copy of the handbook, it is on page 991. I have used this chart so much that it is covered in machine grease, and isn't legible anymore. Any help would be greatly appreciated.
Sincerely,
Donny a.k.a. JustAnotherBubba
I am in need of a copy of the jig boring chart found in the Machinist's Handbook, entitled, "Lengths of Chords for Spacing Off the Circumferences of Circles with a Diameter Equal to 1." In my copy of the handbook, it is on page 991. I have used this chart so much that it is covered in machine grease, and isn't legible anymore. Any help would be greatly appreciated.
Sincerely,
Donny a.k.a. JustAnotherBubba





RE: Need Copy of The Machinist's Handbook Chart for Jig Boring
What is your fax number?
RE: Need Copy of The Machinist's Handbook Chart for Jig Boring
RE: Need Copy of The Machinist's Handbook Chart for Jig Boring
GoshThisSucks@cs.com
I really do appreciate your help with this.
Donny
RE: Need Copy of The Machinist's Handbook Chart for Jig Boring
Sincerely,
Donny