load options
load options
(OP)
Hello,
I am trying to open an assembly with parts specific to the project folder, and additional fasteners from fasteners folder and reference parts from my library folder. altogether 3 folders that one of them is changing from project to another.
When I open the assembly via "search folder" the items from the project folder are not loaded. And when I open it via "form folder", the fasteners are regenerated and find them selves, which is OK, but my reference parts aren't loaded.
I am Using NX8.5.
Is there a way to overcome this issue?
Thanks in advance,
Mor
I am trying to open an assembly with parts specific to the project folder, and additional fasteners from fasteners folder and reference parts from my library folder. altogether 3 folders that one of them is changing from project to another.
When I open the assembly via "search folder" the items from the project folder are not loaded. And when I open it via "form folder", the fasteners are regenerated and find them selves, which is OK, but my reference parts aren't loaded.
I am Using NX8.5.
Is there a way to overcome this issue?
Thanks in advance,
Mor





RE: load options
Try to use the Load option as...
As Saved
Loads the same set of components as when the assembly was last saved.
Thanks,
Mathi K
RE: load options
Thank you,
I will try it.
Mor