Retain Tab is not visible
Retain Tab is not visible
(OP)
Hi all,
i want to set the design point as current for post processing i have enabled Exported column for each design points but In my ansys 15.0 workbench windows Retain tab is not showing which one suggested in this link - https://www.sharcnet.ca/Software/Ans..._exportdp.h....
Is there any alternative way to set design point as current for easy post processing.
i want to set the design point as current for post processing i have enabled Exported column for each design points but In my ansys 15.0 workbench windows Retain tab is not showing which one suggested in this link - https://www.sharcnet.ca/Software/Ans..._exportdp.h....
Is there any alternative way to set design point as current for easy post processing.




