problem getting zero values of stress and deformation in patran
problem getting zero values of stress and deformation in patran
(OP)
hi,
i m a begineer in patran,
i m solving a problem on landing gear strut
i am unable to see the stress and deformation values in results section of patran
it is showing all values to be zero, the legend for both cases shows zero values
in fo6 filr, it shows values for stresses and deformations in different elements but not in results file
attached below photo of the results window
thank you





RE: problem getting zero values of stress and deformation in patran
Regards
bisav
Stress Engineer