Exploded View of Patterned Components
Exploded View of Patterned Components
(OP)
Hello all,
I am using NX 9 and I'm struggling with the following problem.
How can I auto-explode components that were added to the assembly with a circular pattern?
Please see the .jpg attached where you can visualize the problem.
What am I doing wrong?
Thank you and let me know if you need more information.
Best regards,
Ivo Carvalho
I am using NX 9 and I'm struggling with the following problem.
How can I auto-explode components that were added to the assembly with a circular pattern?
Please see the .jpg attached where you can visualize the problem.
What am I doing wrong?
Thank you and let me know if you need more information.
Best regards,
Ivo Carvalho





RE: Exploded View of Patterned Components
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Exploded View of Patterned Components