TURN POSTPROCESSOR WITH HEIDENHAIN CONTROL
TURN POSTPROCESSOR WITH HEIDENHAIN CONTROL
(OP)
Hello Guys
Does anyone has used or created a postprocesor for turning with TNC control
in NX ? is it posible?
I have not found any examples in postbuilder an i have problems starting from
zero in this post.
Do you know where can i find an example to start from of this post?
Thanks
Does anyone has used or created a postprocesor for turning with TNC control
in NX ? is it posible?
I have not found any examples in postbuilder an i have problems starting from
zero in this post.
Do you know where can i find an example to start from of this post?
Thanks




