Opening NX 8.0 Drawing in 9.0
Opening NX 8.0 Drawing in 9.0
(OP)
All,
When opening a Drawing that was created in NX 8.0 in NX 9.0, I'm having multiple view failures. The section views will not update because their lines lost their associativity, the general views are displaying hidden lines as solid and are not modifyable, nothing in the general views is selectable by the annotation commands.
Anybody else experience this? Any solutions?
Thank you!
Andrew
When opening a Drawing that was created in NX 8.0 in NX 9.0, I'm having multiple view failures. The section views will not update because their lines lost their associativity, the general views are displaying hidden lines as solid and are not modifyable, nothing in the general views is selectable by the annotation commands.
Anybody else experience this? Any solutions?
Thank you!
Andrew





RE: Opening NX 8.0 Drawing in 9.0
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.