Translate, Rotate, Copy a Component all at once in NX8.5
Translate, Rotate, Copy a Component all at once in NX8.5
(OP)
I have a need to take a component and translate, rotate and copy it. Think of a skewed lamination of 100 plates. Is this possible or would this require a journal?





RE: Translate, Rotate, Copy a Component all at once in NX8.5
Alternatively, you could use the "pattern component" command.
www.nxjournaling.com
RE: Translate, Rotate, Copy a Component all at once in NX8.5
It's gonna take more time to load a copy and move.
Another great reason not to deprecate the "TRANSFORM" function..
Proud Member of the Reality-Based Community..
To the Toolmaker, your nice little cartoon drawing of your glass looks cool, but your solid model sucks. Do you want me to fix it, or are you going to take all week to get it back to me so I can get some work done?
RE: Translate, Rotate, Copy a Component all at once in NX8.5
RE: Translate, Rotate, Copy a Component all at once in NX8.5
RE: Translate, Rotate, Copy a Component all at once in NX8.5
RE: Translate, Rotate, Copy a Component all at once in NX8.5