Part not showing up in Assembly drawing
Part not showing up in Assembly drawing
(OP)
NX 9.0 I have an assembly model with approximately 30 unique parts. I have created an assembly drawing of this model. 1 of the parts will not show up. I have checked the layer of the part that will not show up. I have updated all the views. The part not showing up is a washer. It is an extra thick washer that I modeled myself, not a download. I have attached a screen shot to help show my problem. Please help.
Thank you,
Trent
NX 8.5.2.3





RE: Part not showing up in Assembly drawing
Best regards,
Michaël.
NX8.5.3 + TC Unified 8.3
Win 7 64 bit
RE: Part not showing up in Assembly drawing
Thank you,
Trent
NX 9.0.3.4
RE: Part not showing up in Assembly drawing
Thank you,
Trent
NX 9.0.3.4
RE: Part not showing up in Assembly drawing
RE: Part not showing up in Assembly drawing
www.nxjournaling.com
RE: Part not showing up in Assembly drawing
Thank you,
Trent
NX 9.0.3.4