Does anyone know if it's possible to use *.ics files to establish bridge geometry (edges of slabs, centerlines of girders, centerline of bearings, etc.) and then use InRoads Bridge to extrude the model? If so, is there any documentation on how one would go about doing this? Thank you
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Since the later 1980s, manufacturing companies have seen over 3 percent in labor output year on year, with most of this productivty enhancement occuring because of the optimization of repetitive tasks. Download Now