Center constraint error issue
Center constraint error issue
(OP)
Hello all,
Using NX 8.5 and I bring in 2 parts, one male and one female, both rectangular profile. When I try to use the Center Constraint using 2 to 2 it will allow me to center one part to the other horizontally but when I do the same for the vertical I get this status: "This constraint cannot solve. Either it references a component that has been deleted or suppressed, or it references geometry that has been deleted suppressed or is now of the wrong type"
Anyone have any idea of how to resolve this?
Thanks,
John
Using NX 8.5 and I bring in 2 parts, one male and one female, both rectangular profile. When I try to use the Center Constraint using 2 to 2 it will allow me to center one part to the other horizontally but when I do the same for the vertical I get this status: "This constraint cannot solve. Either it references a component that has been deleted or suppressed, or it references geometry that has been deleted suppressed or is now of the wrong type"
Anyone have any idea of how to resolve this?
Thanks,
John





RE: Center constraint error issue
Attached is a simple Assembly of something like you described. I created this model in NX 8.5.3.3 and it seems to work fine.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Center constraint error issue
RE: Center constraint error issue
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.