Properties in table of Drawing
Properties in table of Drawing
(OP)
Hello,
I want that the properties that I added on my part (Material, Part Number...) appear in the Table of the drawing that corresponds to the part without having to fill this fields again, but that they appear from them selves.
Can something be programmed or is their a tool that could be used fo that?
Thanks :)
Panchito
I want that the properties that I added on my part (Material, Part Number...) appear in the Table of the drawing that corresponds to the part without having to fill this fields again, but that they appear from them selves.
Can something be programmed or is their a tool that could be used fo that?
Thanks :)
Panchito





RE: Properties in table of Drawing
http://www.eng-tips.com/viewthread.cfm?qid=381431