Gravity Wall - Reinforcement (Flexure and Temperarture/Shrinkage) requirements
Gravity Wall - Reinforcement (Flexure and Temperarture/Shrinkage) requirements
(OP)
I am working on a design of a gravity wall. As expected the requierd flexural reinforcement is less than the temp/srink reinforcement. Do you guys/girls know of any requirements that the area of the flexural reinforcement should be at-least the same as the area for the temp/shrink reinforcement?
Thanks
Thanks






RE: Gravity Wall - Reinforcement (Flexure and Temperarture/Shrinkage) requirements
Mike McCann, PE, SE (WA)