Multiple Parts in a Single Cavity using Moldwizard (NX9)
Multiple Parts in a Single Cavity using Moldwizard (NX9)
(OP)
Ok I have a job I am working on that is two cavities and I use Moldwizard to do my jobs in, molding, then shrink, then it goes to parting, where I split it and create the cavity and core blocks, now here is my question how do you do a two cavity in a single cavity block and still have it use the trim function for your ejector pins, I can not figure out how to do it other then using family tool and split the part twice, which I shouldn't have to do. Any Ideas out there would be greatly welcome. I have a generic parting picture attached to show the idea. I know I can find a work around I'm just trying to find the correct way to do this. John Baker any ideas?





RE: Multiple Parts in a Single Cavity using Moldwizard (NX9)
We have several ways:
Look at this avi.
https://www.dropbox.com/s/7g3249uyiv6yhst/mold_1.a...
This way is good when we have two simple model.
Regards
Marcin
RE: Multiple Parts in a Single Cavity using Moldwizard (NX9)
RE: Multiple Parts in a Single Cavity using Moldwizard (NX9)
regards
Marcin
RE: Multiple Parts in a Single Cavity using Moldwizard (NX9)