Drafting border not at 0,0
Drafting border not at 0,0
(OP)
Gents,
I am using NX Ideas version 5. I have completed a drawing using
drafting package. It seems entire drawing has shifted down and
is being cut of by main border. Any way of repositioning main border
so entire drawing can be seen?
Thanks,
I am using NX Ideas version 5. I have completed a drawing using
drafting package. It seems entire drawing has shifted down and
is being cut of by main border. Any way of repositioning main border
so entire drawing can be seen?
Thanks,





RE: Drafting border not at 0,0
If you do post your question there, please red flag this one for removal.
"Know the rules well, so you can break them effectively."
-Dalai Lama XIV
RE: Drafting border not at 0,0
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli