simulation
simulation
(OP)
Hi people,
I want to make my assembly move or to create some simulation in modelling using the move component tool in assembly tools. I have seen this done before but not sure how to make the assembly move using this? I do not have the license for any of the advanced simulation so that is a no go do any of you have a video of how I can make this work.
Thank you.
Regards Daniel Lamb.
I want to make my assembly move or to create some simulation in modelling using the move component tool in assembly tools. I have seen this done before but not sure how to make the assembly move using this? I do not have the license for any of the advanced simulation so that is a no go do any of you have a video of how I can make this work.
Thank you.
Regards Daniel Lamb.





RE: simulation
You can partially constrain your components so that the degrees of freedom remaining allow you to move the components.
There have been numerous examples posted here and on http://community.plm.automation.siemens.com/
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX7.5, NX9.0, NX10.0(Testing)
Vericut7.3.3