NX direct sketch - enter sketch name box
NX direct sketch - enter sketch name box
(OP)
Currently using NX8.5.3.3
Is it possible to have the "Sketch Name" dialogue box displayed in Direct Sketch
Using the Sketch Task Environment there is a dialogue box displayed where the sketch name can be set to give the sketch a more meaningful name
The only way I can see to change the name of a sketch is use the sketch properties
and change the name via the general tab
Is it possible to have the "Sketch Name" dialogue box displayed in Direct Sketch
Using the Sketch Task Environment there is a dialogue box displayed where the sketch name can be set to give the sketch a more meaningful name
The only way I can see to change the name of a sketch is use the sketch properties
and change the name via the general tab





RE: NX direct sketch - enter sketch name box
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX direct sketch - enter sketch name box
Thanks for the reply