In NX8 drafting, Dimension with arrows out does not show dimesnion lines
In NX8 drafting, Dimension with arrows out does not show dimesnion lines
(OP)
Hello,
When I apply a dimension in NX8 with arrows out the dimension lines do not show (attached jpg file shows example). Can someone help?
Thank you
When I apply a dimension in NX8 with arrows out the dimension lines do not show (attached jpg file shows example). Can someone help?
Thank you





RE: In NX8 drafting, Dimension with arrows out does not show dimesnion lines
See image for where in the customer defaults.
Anthony Galante

Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
RE: In NX8 drafting, Dimension with arrows out does not show dimesnion lines
Tools -> Drafting Standard...
...and simply select the Drafting Standard of interest, and hit OK.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.