CAM: Re-enable warning message
CAM: Re-enable warning message
(OP)
Hi,
I recently had a warning message "Motion to Start of Engage" in CAM.
I accidently checked "Don't display this message again" before clicking on OK and now (as expected) the message doesn't show anymore.
I want to re-enable that message but I can't find it.
I presume it's located somewhere within the customer defaults.
If you know something more, please let me know.
Thanks in advance,
Jeroen
I recently had a warning message "Motion to Start of Engage" in CAM.
I accidently checked "Don't display this message again" before clicking on OK and now (as expected) the message doesn't show anymore.
I want to re-enable that message but I can't find it.
I presume it's located somewhere within the customer defaults.
If you know something more, please let me know.
Thanks in advance,
Jeroen





RE: CAM: Re-enable warning message
I believe it's in Registry key -> HKEY_CURRENT_USER\Software\UNIGRAPHICS SOLUTIONS\NX\9.0\Hide_message
See image below for the hidden warning from my system.
I think if you look at yours you'll find what you're after.
Anthony Galante

Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
RE: CAM: Re-enable warning message
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX7.5, NX9.0, NX10.0(Testing)
Vericut7.3.3
RE: CAM: Re-enable warning message
I've tried the interface preferences option (registery editor seemed a bit more complicated) and it worked.
Thanks!
RE: CAM: Re-enable warning message
Anthony Galante

Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
RE: CAM: Re-enable warning message
www.nxjournaling.com