UCS-56 PWHT
UCS-56 PWHT
(OP)
I have a vessel that is 3/4" thick P1 G1 material. time at temperature as per UCS-56 stated 1 Hr per in, 15 minutes min. Does this get a 45 minute hold time, or the 15 minutes min? Same question for mandatory 1.5" is that 90 mins? or 1 and 15 minute minimum intervals like it does for Above 2"?





RE: UCS-56 PWHT
RE: UCS-56 PWHT
RE: UCS-56 PWHT
Have a good one
RE: UCS-56 PWHT
RE: UCS-56 PWHT
If the material is over 2", the added thickness is done by 15 minute increments.