Snap Point defaults - Can they be changed?
Snap Point defaults - Can they be changed?
(OP)
Hi All,
I have been looking to edit the default settings for Snap Points (specifically to de-select "arc center" as default on). Is there an option to do this somewhere?
Thanks
I have been looking to edit the default settings for Snap Points (specifically to de-select "arc center" as default on). Is there an option to do this somewhere?
Thanks





RE: Snap Point defaults - Can they be changed?
The only place that I can think of is in the customer defaults
But I will need to check at work tomorrow
RE: Snap Point defaults - Can they be changed?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Snap Point defaults - Can they be changed?
I recently moved from 7.5 to 9 and don't remember this being an issue previously.
RE: Snap Point defaults - Can they be changed?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.