Circular imprint
Circular imprint
(OP)
Hi everyone,
I have used circular imprint in NX-9 fem builder. After a couple of operations I would like to edit these imprints and/or suppress them. I don't find how to do so, can someone help me on that?
thank you
I have used circular imprint in NX-9 fem builder. After a couple of operations I would like to edit these imprints and/or suppress them. I don't find how to do so, can someone help me on that?
thank you





RE: Circular imprint
If so, you need to make the _I.part the work part to edit/suppress. ( You can find it in the top of the Simulation navigator)
Or ?
Regards,
Tomas