Drawing dimensions extracted from sketch
Drawing dimensions extracted from sketch
(OP)
Hi all,
I might be going crazy, but I seem to remember about an option in Drafting allowing to automatically create all the dimension from a sketch... Is this even possible, or am I going nuts?...
I might be going crazy, but I seem to remember about an option in Drafting allowing to automatically create all the dimension from a sketch... Is this even possible, or am I going nuts?...

Best regards,
Stely





RE: Drawing dimensions extracted from sketch
RE: Drawing dimensions extracted from sketch
RE: Drawing dimensions extracted from sketch
For some reason, it's not generating for my file... I'll have to play with it a bit.
Thanks again!
Best regards,
Stely
RE: Drawing dimensions extracted from sketch