Realize Shape
Realize Shape
(OP)
I have seen in Siemens PLM Community > NX Design > NX Design Knowledge Base > All TKB Articles in NX Design Knowledge Base
a short demonstration about "Realize Shape" ( by Sam Kuan )
Subject: NX Quick Tips - NX 9 Realize Shape - ( 9 hours ago )
Subdivision modeling offers you both speed and ease when you design a product. Push and pull command).
I was looking to find "Realize Shape" in NX 9, but I couldn't find it!
Could somebody direct my search in this ,matter?
Thanks!
P.S. This is the link:
http://community.plm.automation.siemens.com/t5/for...
a short demonstration about "Realize Shape" ( by Sam Kuan )
Subject: NX Quick Tips - NX 9 Realize Shape - ( 9 hours ago )
Subdivision modeling offers you both speed and ease when you design a product. Push and pull command).
I was looking to find "Realize Shape" in NX 9, but I couldn't find it!
Could somebody direct my search in this ,matter?
Thanks!
P.S. This is the link:
http://community.plm.automation.siemens.com/t5/for...
MZ7DYJ





RE: Realize Shape
Anthony Galante

Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
RE: Realize Shape
MZ7DYJ
RE: Realize Shape
Anthony Galante

Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
RE: Realize Shape
Thanks
MZ7DYJ