NX10 FEM post processing. Where are the minimum and maximum markers??
NX10 FEM post processing. Where are the minimum and maximum markers??
(OP)
Hello,
I am using NX10 FEM advanced simulation.
In post processing I was looking for the MIN and MAX markers (I work with NX75)
button. I could not find them only the min amx markers for a graph.
Anyone any ideas?
Regards,
Olaf
I am using NX10 FEM advanced simulation.
In post processing I was looking for the MIN and MAX markers (I work with NX75)
button. I could not find them only the min amx markers for a graph.
Anyone any ideas?
Regards,
Olaf





RE: NX10 FEM post processing. Where are the minimum and maximum markers??
Yes, in fact, in old versions was more "at hand".
In NX10 You can activate the maximum & minimum annotations in the POST VIEW, se picture:
Best regards,
Blas.
~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director
IBERISA
48004 BILBAO (SPAIN)
WEB: http://www.iberisa.com
Blog de FEMAP & NX Nastran: http://iberisa.wordpress.com/
RE: NX10 FEM post processing. Where are the minimum and maximum markers??
Thanks, I played around in the post view but did not see/expect it to be there.
Regards,
Olaf