pad on shell model technique
pad on shell model technique
(OP)
hi,
i am new to ansys. I want to model a reinforcing pad on a shell, than add a nozzle. Please advice what feature i should you step by step,
Plus it will be very helpful if some can advice me about some book, tutorial or videos about modeling in ansys.
regards,
Inam
i am new to ansys. I want to model a reinforcing pad on a shell, than add a nozzle. Please advice what feature i should you step by step,
Plus it will be very helpful if some can advice me about some book, tutorial or videos about modeling in ansys.
regards,
Inam




