What geometry structure to use for NX turn / mill operations?
What geometry structure to use for NX turn / mill operations?
(OP)
I am currently using the below structure (attached pic) for a turn / mill program. I have selected the blank and part in the Workpiece object in that hierarchy. However, when I run 3D verification for the whole program in NX, milling operations don't show material removal.
Can someone please help figure out what's a good hierarchical structure for turn / mill programs so that 3d verify shows material removal for both turning and milling operations?
Thanks!
Can someone please help figure out what's a good hierarchical structure for turn / mill programs so that 3d verify shows material removal for both turning and milling operations?
Thanks!





RE: What geometry structure to use for NX turn / mill operations?
RE: What geometry structure to use for NX turn / mill operations?
This will show you a good example of organizing the geometry view in the Operation Navigator.
Mark Rief
NX CAM Customer Success
Siemens PLM Software