Moldflow interface with ABAQUS
Moldflow interface with ABAQUS
(OP)
Hi all,
Thanks in advance.
I would like to perform structural analysis of the plastic component.
Please guide me how to do the interface between moldflow simulation and ABAQUS.(step by step procedure)
Thanks in advance.
I would like to perform structural analysis of the plastic component.
Please guide me how to do the interface between moldflow simulation and ABAQUS.(step by step procedure)





RE: Moldflow interface with ABAQUS
http://knowledge.autodesk.com/support/simulation-m...
There's further information on this in the Simualtion Composite Analysis section (odd place for it, I know):
http://knowledge.autodesk.com/support/simulation-c...