CATIA CATShape?
CATIA CATShape?
(OP)
Okay I am trying to figure out a solution for a problem I am having.
In NX you can add multiple parts under one item revision inside Team Center.
In CATIA it is not possible to add multiple parts under one item revision.
Basically what I want to do is put multiple alternate representations of a 3D model under one item revision inside Team Center.
Is this possible? Or does anyone know of any tips or tricks?
I heard that CATShape may allow this functionality. But I don't know enough about it to make a decision. I tried looking on the Dassault site and that didn't yield anything positive.
Thanks in advance for the help.
:D
In NX you can add multiple parts under one item revision inside Team Center.
In CATIA it is not possible to add multiple parts under one item revision.
Basically what I want to do is put multiple alternate representations of a 3D model under one item revision inside Team Center.
Is this possible? Or does anyone know of any tips or tricks?
I heard that CATShape may allow this functionality. But I don't know enough about it to make a decision. I tried looking on the Dassault site and that didn't yield anything positive.
Thanks in advance for the help.
:D




