Ability to constrain new sketch to an existing sketch Nx8
Ability to constrain new sketch to an existing sketch Nx8
(OP)
Hello,
I have used Nx in its earlier versions and I was able to create a new sketch and constrain off of existing sketches. Is there a customer default which I need to activate in order to be able to constrain sketches to each other?
Thanks in advance
I have used Nx in its earlier versions and I was able to create a new sketch and constrain off of existing sketches. Is there a customer default which I need to activate in order to be able to constrain sketches to each other?
Thanks in advance





RE: Ability to constrain new sketch to an existing sketch Nx8
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Ability to constrain new sketch to an existing sketch Nx8
Ronald van den Broek
Application Expert
Wartsila Switzerland Ltd
NX8.5.3 / TC9.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5
HP EliteBook 8570W Intel(R) Core(TM) I7-3740QM CPU @ 2.70GHz, 16Gb Win7 64B