NX 10
NX 10
(OP)
Hello everyone!
I guess the majority already have some knowledge about the launch of NX10!
I'm excited because I saw that this new version has some improvements in 2D,
However... Does anyone know if it has improved the creation of drawing templates?
I guess the majority already have some knowledge about the launch of NX10!
I'm excited because I saw that this new version has some improvements in 2D,
However... Does anyone know if it has improved the creation of drawing templates?





RE: NX 10
RE: NX 10
So far I have applied different methods which are usually long and impractical, besides having to make templates for each sheet type, because I when resize the sheet... the formatting is lost
I've seen some friends perform the same templates in Inventor and make it so much easier
RE: NX 10
RE: NX 10
From that I can't see why you can't make only one template for all possible sheets sizes.
Anthony Galante

Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
RE: NX 10
No, we do not use Teamcenter
RE: NX 10
Hello Phoenx
We designed a template per sheet because the title block was not kept in position when resizing ...
In addition, block size title must change according to the size of sheet