Unable to open part file in NX 8.5
Unable to open part file in NX 8.5
(OP)
Hello All,
Whenever I just double-click a part file,the UG default window is opening(GATEWAY) instead of opening that part file.
However i can open the same part file by first launching NX 8.5 and then say open.
But for some reasons i want that part file to get open by just double-click.
Please can anyone help me in this issue.
Thanks,
Vinit
Whenever I just double-click a part file,the UG default window is opening(GATEWAY) instead of opening that part file.
However i can open the same part file by first launching NX 8.5 and then say open.
But for some reasons i want that part file to get open by just double-click.
Please can anyone help me in this issue.
Thanks,
Vinit





RE: Unable to open part file in NX 8.5
( Note, the problem is not NX but Windows that has lost the correct relationship to ".prt".)
( Windows -start-control panel -add remove programs- NX8.5 - Repair.)
Regards,
Tomas