ANSYS 14 MADPL Path Question
ANSYS 14 MADPL Path Question
(OP)
Hello, I'm doing a run of simulations which has 1 or 2 loads changed. I'm plotting a path and graphing it.
My issue is every time I run a new simulation, I need to redefine my paths each run.
My question is, Is it possible to set the paths so as to keep them defined every sim? I've seen archive path but can not quite figure it out.
Please say there is a way, as it is quite annoying.
Thanks.
My issue is every time I run a new simulation, I need to redefine my paths each run.
My question is, Is it possible to set the paths so as to keep them defined every sim? I've seen archive path but can not quite figure it out.
Please say there is a way, as it is quite annoying.
Thanks.




