NX8.5 datum plane
NX8.5 datum plane
(OP)
I am trying to do something incredibly simple here.
I am trying to created to inferred datum from from another datum plane at a distance (at a cylinder centerline), but it defaults to 90 degrees from the initial datum plane, so when I try to change the 90 to zero degrees the datum plane is still placed at 90 degrees, and it seems like I cannot change it.
So how can I change the default from 90 degrees to zero degrees?
This is so dang frustrating.
I am trying to created to inferred datum from from another datum plane at a distance (at a cylinder centerline), but it defaults to 90 degrees from the initial datum plane, so when I try to change the 90 to zero degrees the datum plane is still placed at 90 degrees, and it seems like I cannot change it.
So how can I change the default from 90 degrees to zero degrees?
This is so dang frustrating.





RE: NX8.5 datum plane
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.