Looking for video topics
Looking for video topics
(OP)
Some of you may be aware that part of my day job is to create NX tip videos for the PhoenxPLM Vimeo site: http://vimeo.com/phoenxplm/videos
Going into the new year, I'd like to get some potential topics or things people would like to see.
Can't guarantee that we'll cover every topic, but we'll try.
Just a warning, videos will be created in NX9/NX10 so don't ask for something to be shown in an older version.
Going into the new year, I'd like to get some potential topics or things people would like to see.
Can't guarantee that we'll cover every topic, but we'll try.
Just a warning, videos will be created in NX9/NX10 so don't ask for something to be shown in an older version.
Anthony Galante
Senior Support Engineer

NX3 to NX10 with almost every MR (21versions)





RE: Looking for video topics
RE: Looking for video topics
Here are a few more (I can't access vimeo from work, so I apologize if I list something that you already have):
www.nxjournaling.com
RE: Looking for video topics
Maybe half a sports car with some complex geometry and cover section surfaces.
Thanks, Bud.
RE: Looking for video topics
@cowski - great list, I'll need to brush up on some of them!
@cobaltred - nearly fell of my chair when I saw this one! however I think a series of short videos covering various techniques to build a SMALL consumer product with class A surfaces is possible
Anthony Galante

Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
RE: Looking for video topics
RE: Looking for video topics
@cobaltred - I ran across a video of someone modeling a sports car body in NX a while back. I only watched the first few minutes; if I remember correctly it was a sped up video of someone creating the surfaces, not much in way of tutorial or instruction, but it may be of interest.
I found it after a little searching:
https://www.youtube.com/watch?v=VNj06waMKpo
www.nxjournaling.com
RE: Looking for video topics
to do some vids that are similar to the Auto desk Alias workbench vids that I suggested and they made a whole webpage for. www.aliasworkbench.com
Would like to see a similar workflow in NX demonstrated.
Thanks, Bud.
RE: Looking for video topics
There are some youtubes on it, but theres not much to go on.
RE: Looking for video topics
Track Drawing changes in 2D drafting. (Goes along with Cowski 2D compare)
Show how to compare two drawings in teamcenter. Not going into NX.
RE: Looking for video topics
Also, there are times when creating the krx option is greyed out and I am unable to figure out why when it seems like I'm doing everything exactly the same as last time.
A little clarity would go a long way to helping with this powerful tool.