Downgrade solid element to plate element
Downgrade solid element to plate element
(OP)
Hi,
Recently I get a model made of solid element from a colleague. Obviously solid element is not necessary for the analysis. Therefore, I am asked to downgrade the model to plate element. But unfortunately there is no geometry in the model. So I am wondering whether there is a quick way in FEMAP to downgrade solid element to plate element. Could anybody answer my question? Thanks in advance.
Regards..
Recently I get a model made of solid element from a colleague. Obviously solid element is not necessary for the analysis. Therefore, I am asked to downgrade the model to plate element. But unfortunately there is no geometry in the model. So I am wondering whether there is a quick way in FEMAP to downgrade solid element to plate element. Could anybody answer my question? Thanks in advance.
Regards..





RE: Downgrade solid element to plate element
RE: Downgrade solid element to plate element
That works. Thanks for your tip.
Regards..
RE: Downgrade solid element to plate element
Regards,